Mounting; Mounting Of The Mounting Bracket - Panasonic SF4C Series Instruction Manual

2-4 Mounting

2-4-1 Mounting of the Mounting Bracket

● Do not apply the load such as forced bending to the cable of this device. Applying improper load
could cause the wire breakage.
● The minimum bending radius of the cable is R6mm. Mount the device with considering the cable
bending radius.
<Reference>
● Mount the emitter and the receiver at the same level and parallel to each other. The effective aperture angle of this de-
vice is ±2.5° or less at a sensing distance of 3m.
● Unless otherwise specified, the following mounting procedure is common for both emitter and receiver. For the prepa-
ration of the mounting, prepare the mounting holes on the mounting surface by referring to "6-3 Dimensions."
<In case of using standard mounting bracket MS-SFC-1 (accessory)>
● Direction of the standard mounting bracket MS-SFC-1 which is attached to this device can be changed de-
pending on the mounting position of the device.
1. Remove the M3 countersunk head screw [with anti-loosening agent (length 4mm)] which is attached to the
back of the device.
2 Decide the direction of the standard mounting bracket.
3. Tighten with the M3 countersunk head screw [with anti-loosening agent (length 4mm)].
The tightening torque should be 0.3N·m.
M3 countersunk head screw
[With anti-loosening agent (length 4mm)]
● Install the standard mounting brackets in the mounting surface with two hexagon-socket head bolts
[M5 (purchase separately)].
© Panasonic Industrial Devices SUNX Co., Ltd. 2016
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Standard mounting bracket
MS-SFC-1 (Accessory)
Hexagon-socket head bolt
[M5 (Purchase separately)]
Mountable in three directions
This device
Mounting
This device
19