Device Placement - Panasonic SF4C Series Instruction Manual

Protection Area

2-3-4 Device Placement

This is the configuration when two or more sets of emitter and receiver facing each other are placed. It is
used for system evaluation in case of addition of equipment. Perform an operation test by referring to "2-6-2
Operation Test."
● Refer to the examples of device placement given below and understand them thoroughly before in-
stalling the devices.
Improper sensor placement could cause device malfunction, which can result in death or serious injury.
● If this device is used in multiple sets, arrange them to avoid mutual interference.
If mutual interference occurs, it can result in death or serious injury.
<Example of device placement>
1) Install the emitter and the receiver back to back.
Receiver Emitter
3) Arrange the emitter and the receiver horizontally on
opposite sides.
Emitter
Receiver
<Reference>
The above figures are just examples of device placement. If there are any questions or problems, please contact our office.
Position the emitter and receiver so that their cables are aligned. Failure to do so will cause the system
to malfunction.
18
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
2) Arrange the emitter and the receiver vertically on
opposite sides.
Emitter Receiver
4) Install a barrier
Receiver
Receiver
Emitter
Cable
Emitter
Receiver
Emitter Receiver
Barrier
Cable Cable
© Panasonic Industrial Devices SUNX Co., Ltd. 2016
Receiver
Emitter
Emitter
Cable