Error Messages; Specifications; Troubleshooting Guide - Sony STR-DN610 Operating Instructions Manual

Error messages

If there is a malfunction, the display shows a
message. You can check the condition of the
system by the message. See the following table
to solve the problem. If any problem persists,
consult your nearest Sony dealer.
If an error message appears while you perform
Auto Calibration, see "When error codes
appear" (page 34) to solve the problem.
PROTECTOR
Irregular current is output to the speakers, or
the upper panel of the receiver is covered
with something. The receiver will
automatically turn off after a few seconds.
Check the speaker connection and turn on
the power again.
If you are unable to remedy the
problem using the

troubleshooting guide

Clearing the receiver's memory may remedy
the problem (page 31). However, note that all
memorized settings will be reset to their initial
settings and you will have to readjust all
settings on the receiver.
If the problem persist
Consult your nearest Sony dealer. Note that if
service personnel changes some parts during
repair, these parts may be retained.
Reference sections for clearing
the receiver's memory
To clear
All memorized settings
Customized sound fields

Specifications

Amplifier section
Models of area code CA2
Minimum RMS Output Power
(8 ohms, 20 Hz – 20 kHz, THD 0.09%)
Stereo Mode Output Power
(8 ohms, 1 kHz, THD 1%)
Surround Mode Output Power
(8 ohms, 1 kHz, THD 10%)
Models of area code CEK, ECE
Minimum RMS Output Power
(8 ohms, 20 Hz – 20 kHz, THD 0.09%)
Stereo Mode Output Power
(8 ohms, 1 kHz, THD 1%)
Surround Mode Output Power
(8 ohms, 1 kHz, THD 10%)
1)
Measured under the following conditions:
Area code
CA2
CEK, ECE
2)
Reference power output for front, center, surround
and surround back speakers. Depending on the
sound field settings and the source, there may be
no sound output.
Frequency response
Analog
Input
Analog
See
page 31
Digital (Coaxial) Impedance: 75 ohms
page 49
1)
85 W + 85 W
105 W + 105 W
2)
140 W per channel
1)
85 W + 85 W
100 W + 100 W
2)
140 W per channel
Power requirements
120 V AC, 60 Hz
230 V AC, 50 Hz
10 Hz – 70 kHz,
+0.5/–2 dB (with sound
field and equalizer
bypassed)
Sensitivity: 500 mV/
50 kohms
3)
S/N : 96 dB
4)
(A, 500 mV )
S/N: 100 dB
(A, 20 kHz LPF)
continued
79
GB