Viewing Information On The Display - Sony STR-DN610 Operating Instructions Manual

Naming inputs
You can enter a name of up to 8 characters for
inputs (except TUNER) and display it on the
receiver's display.
This is convenient for labeling the jacks with
the names of the connected components.
1
Press one of the input buttons
to select the input you want to
create an index name for.
You can also use INPUT SELECTOR
+/– on the receiver.
2
Press AMP MENU.
3
Press V/v repeatedly to select
"SYSTEM", then press
4
Press V/v repeatedly to select
"NAME IN", then press
The cursor flashes and you can select a
character.
5
Press V/v to select a character,
then press B/b to move the
cursor to the next position.
If you made a mistake
Press B/b until the character you want to
change flashes, then press V/v to select
the correct character.
Tips
• You can select the character type as follows
by pressing V/v.
Alphabet (upper case) t Numbers t
Symbols
• To enter a blank space, press b without
selecting a character.
6
Press .
The name you entered is registered.
GB
38
Viewing information on
the display
You can check the sound field, etc., by
changing the information on the display.
Press DISPLAY repeatedly.
Each time you press the button, the display
or b.
changes cyclically as follows:
All inputs except the FM and AM
or b.
band
Index name of the input
t Sound field currently applied t Volume
level t Stream info
FM and AM band
Program Service name
a)
t Frequency t Program Type
name
indication
Current Time indication (in 24-hour system
b)
mode)
Volume level
a)
Index name appears only when you have assigned
one to the input or preset station (page 38, 43).
Index name does not appear when only blank
spaces have been entered, or it is the same as the
input name.
b)
RDS
During
CEK, ECE only) (page 44).
Note
Character or marks may not be displayed for some
languages.
O
a)
t Selected input
b)
or preset station
b)
t Radio Text indication
t Sound field currently applied t
reception only (Models of area code
DISPLAY
b)
t