Direct Tuning - Sony STR-DN610 Operating Instructions Manual

Tuning into a station
automatically (Automatic
Tuning)
1
Press TUNER repeatedly to
select the FM or AM band.
2
Press TUNING + or TUNING –.
Press TUNING + to scan from low to
high; press TUNING – to scan from high
to low.
The receiver stops scanning whenever a
station is received.
In case of poor FM stereo
reception
If the FM stereo reception is poor and "ST"
flashes on the display, select monaural audio
so that the sound will be less distorted.
1
Press AMP MENU.
2
Press V/v repeatedly to select "TUNER",
then press or b.
3
Press V/v repeatedly to select "FM
MODE", then press
4
Press V/v repeatedly to select "MONO",
then press .
To return to stereo mode, repeat steps 1 to 4
and select "STEREO" in step 4.
or b.
Tuning into a station directly

(Direct Tuning)

You can enter the frequency of a station
directly by using the numeric buttons.
1
Press TUNER repeatedly to
select the FM or AM band.
You can also use INPUT SELECTOR
+/– on the receiver.
2
Press D.TUNING.
3
Press and hold SHIFT, then
press the numeric buttons to
enter the frequency.
Example 1: FM 102.50 MHz
• Models of area code CA2:
Select 1 b 0 b 2 b 5
• Models of area code CEK and ECE:
Select 1 b 0 b 2 b 5 b 0
Example 2: AM 1,350 kHz
Select 1 b 3 b 5 b 0
4
Press and hold SHIFT, then
press ENTER.
Tip
If you have tuned in an AM station, adjust the
direction of the AM loop antenna (aerial) for
optimum reception.
If you cannot tune in a station
Make sure you have entered the right
frequency. If not, repeat steps 2 to 4. If you
still cannot tune in a station, the frequency is
not used in your area.
GB
41