Required Tools; Package Contents; Environmental Requirements; Environmental Requirements - Lenovo ThinkSystem NE10032 RackSwitch Installation Manual

Required Tools

Package Contents

Environmental Requirements

© Copyright Lenovo 2019
For convenience, once the NE10032 is installed and initialized, you can use the
following command in the switch firmware interface to display the product serial
number and other required information:
NE10032> show sys-info
For more information, see
You need the following tools or equipment to install the NE10032:
Standard flat-blade screwdriver

 #2 Phillips screwdriver
Electrostatic discharge wrist strap

The basic NE10032 package contains the following items:
 One ThinkSystem NE10032 unit with front-to-rear or rear-to-front airflow
 One two-post mounting kit for standard 19" equipment racks:
Two mounting brackets

Screws to attach brackets to the switch unit

Screws to attach the switch unit to the equipment rack

 One console cable kit that includes:
One RJ45 to DB9 serial console cable

One Micro-USB Type B to USB Type A console cable

One Micro-USB Type A to USB Type A cable

 One power cord retention bracket
 One Important Notices document
 One Warranty Information document
For a list of compatible switch components and options (such as rack-mounting kits,
modules, cords, and cables), see the
This section describes the basic environmental requirements for the NE10032. Make
sure the location where you install the switch meets the following requirements:
 Install the switch unit in a dry, clean, well-ventilated area.
 Provide adequate space in the front and back of the switch unit, to ensure proper
air flow.
Make sure that an adequate grounded power supply is within reach of the

switch unit.
 Make sure that twisted-pair cable is routed away from power lines, fluorescent
lighting fixtures and other sources of electrical interference.
"Configuring Vital Product Data" on page
Lenovo Networking
Chapter 3: Installing NE10032 Hardware and Options
74.
Catalog.
37