Required Tools; Package Contents; Environmental Requirements - Lenovo RackSwitch G8264 Installation Manual

Required Tools

Package Contents

Environmental Requirements

© Copyright Lenovo 2017
For convenience, once the G8264 is installed and initialized, you can use the
show sys­info command in the switch firmware interface to display the product
serial number and other required information. For more information, see
"Configuring Vital Product Data" on page
You need the following tools or equipment to install the G8264:
 Standard flat‐blade screwdriver
 #2 Phillips screwdriver
Electrostatic discharge wrist strap

The basic G8264 package contains the following items:
 One RackSwitch G8264 unit with front‐to‐rear or rear‐to‐front airflow
One two‐post mounting kit for standard 19" equipment racks:

Two mounting brackets

Screws to attach brackets to the switch unit

Screws to attach the switch unit to the equipment rack

One console cable kit that includes:

One Mini‐USB to RJ‐45 serial cable

One Category 5 patch cable

One DB9 to RJ‐45 adapter

 Two AC power cords
 One Documentation CD, which includes the Systems Information document
 One Environmental Notices CD
 One Important Notices document
 One Warranty Information document
For a list of compatible switch components and options (such as rack‐mounting kits,
modules, cords, and cables), see the Lenovo Networking Catalog.
This section describes the basic environmental requirements for the G8264. Make
sure the location where you install the switch meets the following requirements:
 Install the switch unit in a dry, clean, well‐ventilated area.
 Provide adequate space in the front and back of the switch unit, to ensure proper
air flow.
 Make sure that an adequate grounded power supply is within reach of the
switch unit.
 Make sure that twisted‐pair cable is routed away from power lines, fluorescent
lighting fixtures and other sources of electrical interference.
72.
Chapter 3: Installing G8264 Hardware and Options
33