Remove Dynamics Ecu Bracket* And Pocket Screw; Remove Lower Pocket And Passenger Side Cubby; Remove Center Switch Hardware - MB QUART STAGE 5 Installation Manual

DASH AREA DISASSEMBLY 2018.5 Turbo S & 2019 RZR - Continued
STEP 4 – REMOVE DYNAMICS ECU BRACKET* AND POCKET SCREW
Remove (4) 10mm bolts holding the Dynamics ECU bracket as shown in Figure 7-4a. Move the ECU to the
side leaving wire connection intact. Even if there is no ECU present, the bracket is still there. Next remove
(1) T40 screw on the pocket support bracket underneath the ECU bracket as shown in Figure 7-4b.
Figure 7-4a
STEP 5 – REMOVE LOWER POCKET AND PASSENGER SIDE CUBBY
Remove lower pocket by pulling forward as shown in Figure 7-5a. If you have Ride Command you will also
have to disconnect the USB cable. Next, remove (2) plastic push clips in the passenger side cubby as
shown in Figure 7-5b. Then remove cubby and set aside.
Figure 7-5a
STEP 6 – REMOVE CENTER SWITCH HARDWARE
Remove (4) T40 screws located above the center
switches as in Figure 7.6a. If you have a Ride
Command, (2) will be on each side of the screen and (2)
behind the screen as in Figure 7.6b.
Figure 7-6a
10
Figure 7-4b
Figure 7-5b
Figure 7-6b
©2019 Maxxsonics USA, Inc.