Subwoofer Enclosure Mounting (All Models); Position And Begin Mounting Subwoofer; Finish Subwoofer Mounting; Route Subwoofer Harness - MB QUART STAGE 5 Installation Manual

SUBWOOFER ENCLOSURE MOUNTING (ALL MODELS)

With the subwoofer installed in the enclosure and the glove box door in position from earlier preparation
steps, you are ready to mount the subwoofer into the glove box location. For those applications on 2018.5
Turbo S and 2019+ RZR models, ensure you've completed the modification shown on page 6.
STEP 1 – POSITION AND BEGIN MOUNTING SUBWOOFER_ ENCLOSURE
Sitting on the floor of the RZR, hold the subwoofer enclosure up to the grab bar pipe. Sitting on the floor
of the RZR, hold the subwoofer enclosure up to the grab bar pipe. Mount the subwoofer to the RZR using
the supplied steel plates (2), the (8) nuts, and
(8) washers shown in Figure 11-1. Use your
1/2 inch socket with a small ratchet to begin
tightening the nuts. Space is tight for any larger
tools, a smaller ratchet will work best.
NOTE – Ensure the wiring harness from the
subwoofer does not get pinched behind the
enclosure. This will prevent the enclosure from
seating properly and will not allow the front
dash to snap into place properly The harness
should be routed over the top of the push bar
frame to the subwoofer amplifier connector.
Figure 11-1
STEP 2 – FINISH SUBWOOFER MOUNTING
Figure 11-2
Tighten a few threads at a time on each bolt to
allow the subwoofer to rise up against the pull
bar frame evenly. This will allow the subwoofer
to seat properly against the frame of the
vehicle. As the subwoofer enclosure comes
up against the grab bar pipe, before it is finally
secure, make sure that the speaker wire is not
behind the enclosure. Once verified, bolt the
subwoofer tightly into place.
NOTE – When the subwoofer starts to seat
Push Forward While Tightening
into place, push the subwoofer firmly forward
as shown in Figure 11-2 as you tighten the last
thread with the mounting nuts. This forward
pressure will be critical when you reassemble the front
Mono
dash for fitment into all the clips.
Amplifier
STEP 3 – ROUTE SUBWOOFER HARNESS
Route the subwoofer enclosure's harness over to the
Figure 11-3
amplifier area. Connect it to the speaker output of the
mono amplifier as shown in Figure 11-3.
The next section describes connecting the other wiring
harnesses to the amplifiers.
Subwoofer Enclosure
16
©2019 Maxxsonics USA, Inc.