Dash Area Disassembly; Remove Center Hood; Remove Top Of Dash; Remove The Grab Bar - MB QUART STAGE 5 Installation Manual

DASH AREA DISASSEMBLY 2013-2018 (Non-Turbo S) RZR
Please note, separate disassembly instructions for the 2018.5 Turbo S and 2019 RZR models are found on
pages 9-11 in this manual.
Figure 6-1
STEP 1 – REMOVE CENTER HOOD
Start with removing the hood as shown in Figure 6-1.
Twist the tabs at the upper left and right corners. Pull
up to remove. This is where you will access the bus bar
described on page 3 of this manual. Confirm that your
machine has the busbar installed by the dealer or by
you. If your busbar harness has not been installed, you
can purchase from your dealer or Polaris online. The
part numbers are 2881551 or 2881646 depending on
which specific RZR model you own.
STEP 2 - REMOVE TOP OF DASH
Remove (2) T-40 screws as shown in Figure 6-2. Slide dash forward to access back of dash and unplug
gauges and switches one at a time. Set dash aside in a safe location.
STEP 3 – REMOVE THE GRAB BAR
Remove the grab bar as shown in Figure 6-3 by removing the retaining clip and pin and firmly pulling the
grip toward the rear of the vehicle.
Figure 6-2
Figure 6-3
STEP 4 - REMOVING DASH POCKET & REAR MOUNT
To remove the DIN dash pocket from the dash, locate the rear support bracket at the rear of the pocket and
remove the Torx head screw as in Figure 6.4a. Next, remove the clip shown on the right from the back and
pull out the plastic pocket. Set aside the retaining clip for re-use when mounting your new dash source unit
as shown in Figure 6-4b.
Set aside OEM dash clip for source unit
mounting later in the installation.
Torx Screw
Figure 6-4b
Figure 6-4a
7