Mount Kick Panels; Connect Wire Harness Into Kick Panels; Wire The Front Speakers; Mount The Front Speakers - MB QUART STAGE 5 Installation Manual

STEP 4 – MOUNT KICK PANELS
Using the 5/16 inch bolts, washers, and nuts, mount
the kick panel as shown in Figure 14-4. Make sure you
use a washer on the inside of the enclosure against the
internal wall of the pod which you sandwich against the
fender of the RZR. Use your 1/2 inch ratchet and wrench
to secure the pod.
NOTE - Make sure that the wires behind the enclosure
have remained accessible for connecting to the amplifier
harness. Use some painters tape to keep them from
Figure 14-4
getting blocked by the enclosure if necessary.
STEP 5 – CONNECT WIRE HARNESS INTO KICK PANELS
Connect the wire harness from the amplifier that you routed earlier to the wire harness from the kick panel.
STEP 6 – WIRE THE FRONT SPEAKERS
Identify the harness wires from inside of each pod and connect the wires to the back of the compression
horn speakers as shown in Figure 14-5a. Connect speaker wires as shown in Figure 14-5b. If your kick
panel speakers also feature illumination, connect those wires as well.
Figure 14-5b
Figure 14-5a
STEP 7 – MOUNT THE FRONT SPEAKERS
With the speakers properly wired, mount the speaker to the enclosure. Position the speaker (with the
compression horn backplate removed) in the enclosure and mount with the included hardware as shown in
Figure 14-6a. We suggest mounting with hand tools to stripping out the mounting hardware or damaging the
speakers. Final speaker position is shown in Figure 14-6b. Repeat steps 3-7 on the passenger's side.
Figure 14-6a Figure 14-6b
NOTE - Refer to the compression horn diaphragm replacement manual included with the speakers called
MBQ-POD if you have not yet remove the back plate to accommodate the kick panel depth.
20
©2019 Maxxsonics USA, Inc.