Remove Seats; Unbolt And Mark Center Console Hardware; Remove Center Console - MB QUART STAGE 5 Installation Manual

REMOVE SEATS AND CENTER CONSOLE (ALL MODELS)
STEP 1 – REMOVE SEATS
Remove driver and passenger seats by pulling on the lock clip shown in Figure 8-1. This lock clip is located
between the bottom and upright portion of the seat.
Behind the seats in the center of the machine is the panel where you access the oil filter. You will need to
remove this as shown in Figure 8-1b in order to feed and secure the rear speaker harness if not routing the
rear speaker harness inside the body panels.
Figure 8-1a Figure 8-1b
STEP 2 - UNBOLT AND MARK CENTER CONSOLE HARDWARE
Use the painters tape to mark where you remove each of the push pins and/or T-40 screws in the seat
side and seatbelt area as shown in Figure 8-2a. Remove and mark the final T-40 screw at the front of the
console. We recommend using small disposable cups or sealable sandwich bags to label the different
screws in order keep track of them for reassembly.
Figure 8-2a Figure 8-2b
STEP 3 - REMOVE CENTER CONSOLE Figure 8-3
Gently push the shifter and seat belt boots back through
the console as show as shown in Figure 8-3. Carefully
remove center console from vehicle. Set aside in a safe
location until it's time for reassembly.
12
©2019 Maxxsonics USA, Inc.