Setting Remote Control Codes That Are Not Stored In The Remote Control - Sony STR-DA5800ES Operating Instructions Manual

Setting remote control
codes that are not stored
in the remote control
Even if a remote control code is not one of the
presets stored in the remote control, it is
possible for the remote control to learn the
code using the learning function.
FAVORITES
SHIFT
Input
buttons
Buttons
used to
learn
code
* To store a new command on one of those buttons,
press SHIFT beforehand.
1
Press FAVORITES while
pressing RM SET UP.
The RM SET UP button lights up.
When the memory capacity for storing
remote control codes reaches a certain
limit, the RM SET UP button flashes 10
times, and then the learning process is
finished.
2
Press the input button
(including the TV button) for the
equipment you want to operate
with the new command.
The input button flashes. (The RM SET
UP button remains lit.)
Even if you press an input button on
RM SET
which you cannot store a new command
UP
such as PC or SOURCE, etc., the input
?/1
button will not flash.
3
Press the button on which you
want to store the new
command. For the buttons with
Buttons
used to
an asterisk in the illustration
learn
above, press SHIFT, then press
code*
the button.
The input button you selected in step 2
lights up. (The RM SET UP button
remains lit.)
When the learning process fails, the RM
SET UP button flashes five times.
If you fail to store the new command,
make sure that a command has not
already been stored on the button on
which you want to store the new
command.
If you want to store the new command on
the button on which you have already
stored the command, erase the stored
command beforehand.
4
Point the remote control code
receiver section of the remote
control toward the transmitter
on the remote control to be
learned from.
About 5 cm - 10 cm
continued
129 GB