Setting Remote Control Codes That Are Not Stored In Quick Click - Sony 3-875-814-21(1) Operating Instructions Manual

Setting remote control
codes that are not stored
in Quick Click
1
Press AMP.
The receiver can be operated using the
remote.
2
Press MENU.
The menu is displayed on the TV screen.
3
Press V/v repeatedly to select
" Settings," then press
b.
4
Press V/v repeatedly to select
"Quick Click," then press
b.
5
Press V/v repeatedly to select
"Source Component," or
"Common Component," then
press .
146
GB
6
Press V/v repeatedly to select
the component you want, then
press
7
Press V/v repeatedly to select
"Learn Mode," then press
8
Press V/v repeatedly to select
the code number you want to
store as the new command,
AMP
then press
9
Keep pressing the
corresponding button on the
remote of the component to be
programmed while pointing the
remote towards the receiver's
remote sensor until
"Complete" is displayed on the
TV screen.
V/v/B/b,
MENU
"Test" is selected automatically after few
seconds when the registration of a new
code is completed.
10
Press
or
The operation test of the programmed
code is started.
Proceed to step 11 if you will not perform
the operation test.
or
11
Press V/v/B/b repeatedly to
select "Finish."
Note
The display window is turned off while the receiver
is registering the new code.
.
.
Remote sensor
About 5 cm - 10 cm
.
.