Saving the measurement results
To save the measurement results obtained in
"Performing auto calibration" (page 48),
proceed with the following steps.
Press B/b to select "Yes" in
step 8 in "Performing auto
calibration," then press
The selecting screen of the calibration
Press V/v repeatedly to select
the auto calibration type, then
Makes the measurement of
frequency from each
Sets the frequency to one
that matches that of the
Sony listening room
Front Reference Adjusts the characteristics
of all the speakers to match
the characteristics of the
Sets the auto calibration EQ
The measurement results are saved.
The exit screen appears.
• After reflecting the results of a compensation for a
frequency characteristic, signals with a sampling
frequency of higher than 96 kHz are always played
back at either 44.1 kHz or 48 kHz.
• The frequency response measurement result is not
utilized in the following cases.
– The multi-channel input is selected.
– "2ch Analog Direct" is being used.
• The measurement result is not utilized when Dolby
TrueHD signals with a sampling frequency of
higher than 96 kHz are being received.
The size of a speaker (LARGE/SMALL) is
determined by the low characteristics. The
measurement results may vary, depending on the
position of the optimizer microphone and speakers,
and the shape of the room. It is recommended that
you follow the measurement results. However, you
can change those settings in the Speaker settings
menu. Save the measurement results first, then try to
change the settings if you want.