Stornext Operations - Quantum StorNext M330 Hardware Manual

StorNext Operations

StorNext M330 Metadata Appliance Hardware Guide
9 Type the sudo rootsh command to grant root user privileges after
entering the password for the stornext user account again when
prompted.
10 From the command line, update the VIP Address using the following
command (refer to the vip_control man page or the
Pages Reference Guide
vip_control
11 To update the firewall rules for the MDC node operating as the
primary, type the following:
/opt/DXi/scripts/netcfg.sh --reset_snvip
For more information on performing advanced StorNext operations,
refer to the following within this document or by accessing documents
from the StorNext M330 GUI:
• For information on how to monitor the hardware components for
both MDC nodes, refer to the "The Hardware Status Report" section
of the latest version of the
• For instructions on how to capture system state logs and support
bundles, refer to the "The Capture State Function" section of the
latest version of the
• For instructions on how to capture DSET logs, refer to the "Capture
DSET" section of the latest version of the
• For information on changing the network configuration, refer to the
"Step 3: System" section of the latest version of the
Guide
.
• For information on setting up the distributed data mover (DDM)
feature, refer to "Distributed Data Mover (DDM)" section of the
latest version of the
• For information on StorNext Advanced Reporting, refer to the
StorNext Advanced Reporting User's Guide
Chapter 3: Basic System Operations
Additional Common Operations
for information on changing the address).
StorNext User's Guide
StorNext User's Guide
StorNext User's Guide
StorNext Man
.
.
StorNext User's Guide
StorNext User's
.
.
.
51