Pavone Systems MCT 1302 Technical Manual page 48

TABLE CALIBRATION
It allows you to manually program up to 5 calibration points, in addition to the zero value. The values
correspond to those determined by the linearization procedure with sample weights. In this way, it is
possible to display the values determined automatically with this procedure, or modify and program
them according to preset values.
MESSAGE
Zero signal Signal value corresponding to the zero scale.
Value of weight Weight value corresponding to the 1st calibration
P1 point.
Signal P1 Signal value corresponding to the 1st calibration point. mV/V
Value of weight Weight value corresponding to the 2nd calibration
P2 point.
Signal value corresponding to the 2nd calibration
Signal P2
point.
Value of weight Weight value corresponding to the 3rd calibration
P3 point.
Signal value corresponding to the 3rd calibration
Signal P3
point.
Value of weight Weight value corresponding to the 4th calibration
P4 point.
Signal P4 Signal value corresponding to the 4th calibration point. mV/V
Value of weight Weight value corresponding to the 5th calibration
P5 point.
Signal P5 Signal value corresponding to the 5th calibration point. mV/V
Zero Signal Signal acquisition function, in mV/V, corresponding to
Acquisition the zero scale
The values programmed to zero are not taken into account. Table calibration is automatically canceled
when a new theoretical calibration or a sample weight is performed.
Following the execution of the zero signal acquisition function, the signals in the table are recalculated.
At each signal value an offset is added, obtained from the difference between the new acquired zero
signal and the old zero signal value.
Page 46
TABLE CALIBRATION
DESCRIPTION UNITS
mV/V
Weight measurement
unit
Weight measurement
unit
mV/V
Weight measurement
unit
mV/V
Weight measurement
unit
Weight measurement
unit