Pavone Systems MCT 1302 Technical Manual page 30

Message
Alphanumeric name of the activity.
Selection of the activity type. (*)
Fine is the amount of weight that
you want to batch at reduced
speed. This value must be less than
the set value set in the recipe. By
programming this value to zero, the
component is batched entirely at
Coarse output.
Parameter used only for "activity
type"" = AUTO DOS..
The Inflight is the amount of material
that by inertia of the system is
added to the batched material
after the Fine batching output has
switched off.
The settable value must be less
than the set value set. Load output
deactivation set point = value set -
Inflight
Parameter used only for "activity
type"" = AUTO DOS..
This parameter, if different from
zero, applies an automatic
correction of the inflight value. At
the end of each automatic batching
activity, the difference between
the batched value and the set is
checked. This difference is used
to calculate the new inflight value,
based on the percentage set in this
parameter. The value obtained is
limited to 10% of the activity set
value and in any case cannot be
higher than the tolerance value.
Page 28
ENTER AND EDIT ACTIVITY
Description Type Units Default
Max. 14
0 alphanumeric
characters
[0] AUTO DOS.
[1] MAN. DOS.
[2] TOT. UNL.
[3] INT. UNL
0 [4] SET ACT.
[5] TIMER
[6] OUTPUT
[7] INPUT
[8] UNL. DOS.
0 0÷Cell capacity
0 0÷Cell capacity
0.0 0.0 ÷ 100.0
Fieldbus
Range
address
0252-
0258
0259
0260
(MSW)
-
0261
(LSW)
0262
(MSW)
-
0263
(LSW)
0275