Batching Parameters Menu - Pavone Systems MCT 1302 Technical Manual

Message Description
This parameter represents the
control set point of zero.
This set point determines the
maximum weight value allowed at
the start of the BATCHING; with a
higher weight, the batching will not
start and the instrument will display
an error message. To disable this
control, reset the value of this set
point.
This parameter represents the empty
scale set point. This set point is
checked during unloading: when
the weight falls below this set point,
the unloading phase is considered
complete.
This parameter represents the
time of the unloading extension:
during complete unloading (not set)
when the weight becomes lower
than empty scale tset point, the
unloading phase is prolonged for
the programmed time, to ensure the
complete unloading of the tank.
This parameter represents the
unloading end time: at the end of
the unloading phase, this time is
waited before moving on to the
next step of the recipe (in the case
of intermediate unloading), or
before deactivating the cycle output
in progress (in the case of final
unloading of the batching cycle).
This parameter represents the end
of cycle time that passes from
the end of the last phase of the
batching cycle to the beginning of
a new batching cycle (in case of
automatic repetition of the cycles)
or the enabling of a new START
batching command.
This parameter represents the
activation time of the end of cycle
output, which is activated at the end
of the last phase of the batching
cycle.

BATCHING PARAMETERS MENU

BATCHING PARAMETERS
Type Units Default
0
0
0
0
0
0
Fieldbus
Range
address
0101
(MSW)
0÷Load Cell
-
capacity
0102
(LSW)
0103
(MSW)
0÷Load Cell
-
capacity
0104
(LSW)
0.0÷999.9 0105
0.0÷999.9 0106
0.0÷999.9 0107
0.0÷999.9 0108
Page 35