Pavone Systems MCT 1302 Technical Manual page 38

In the case of CONFIRM selection,
at the beginning of the total
unloading activity, the net weight
batched in the recipe is displayed.
To activate the unloading output,
the operator must press the
confirmation key or close the input
set in the activity.
In case of FACTOR selection,
the correction of the recipe
is performed by entering a
multiplication factor of the sets
(from 0.01 to 10.00). In the case of
WEIGHT selection, the correction of
the recipe is performed by entering
the total weight value that you wish
to batch; the recipe sets will be
automatically recalculated to obtain
the desired total.
This parameter represents the
minimum level set point compared
to the gross weight. The minimum
level output activates when the
weight is lower than the set value.
This parameter represents the
maximum level set point compared
to the gross weight. The maximum
level output activates when the
weight is greater than the set value.
Output associated with the minimum
level value. "NA" operating logic,
activated when the gross weight is
lower than the minimum level set
point. In the case of a parameter set
to 0, no output is associated.
Output associated with the
maximum level value. "NA"
operating logic, activated when
the gross weight is greater than the
maximum level set point. In the case
of a parameter set to 0, no output is
associated.
Output associated with the
execution of a batching cycle.
"NA" operating logic, it is activated
with the start of the batching
and deactivated at the end of
the batching. In the case of a
parameter set to 0, no output is
associated.
Page 36
[0] NORMAL
0
[1] CONFIRM
[0] FACTOR
0
[1] WEIGHT
0÷Load Cell
0
capacity
0÷Load Cell
0
capacity
0 0÷32
0 0÷32
0 0÷32
0109
0110
0111
(MSW)
-
0112
(LSW)
0113
(MSW)
-
0114
(LSW)
0115
0116
0117