Table of Contents
Advertisement
AVG1 Analog Video Generator User Manual
Installing Signals to the Default Destination. To install signal sets from the disk to
the default destination, perform these steps:
1. Insert the test signal disk into the TG 2000 Platform mainframe disk drive.
2. Push the DISK button.
3. Touch Add Signals when the Disk menu appears.
4. Touch Select Source.
5. Move the cursor to the .DNL you want to load and push the Select button.
6. Select all of the signal sets at the module level and push the Select button.
7. Touch Quit/Load. The previous menu appears.
8. Touch Quit/Load again. The Add Signals window reappears, showing the
module as the selected destination.
NOTE. The Add Signals window shows the amount of Kbytes selected (Total
Tagged) and the amount available on the module. If the tagged total is greater
than the amount available, the signal set will not load.
9. Touch Start Load. The signal sets are automatically loaded into the module.
A popup menu tells you when the transfer is complete.
Installing Signals to a Non-default Destination. To install signal sets from the
floppy disk to a non-default destination, perform these steps:
1. Insert the test signal disk into the TG 2000 Platform mainframe disk drive.
2. Push the DISK button.
3. Touch Add Signals when the Disk menu appears.
4. Touch Select Source.
5. Move the cursor to the .DNL you want to load and push the Select button.
6. Move the browse ring to a particular test signal and push the Select button.
7. Touch Quit/Load. The previous menu appears.
8. Touch Quit/Load again. The Add Signals window reappears.
Appendix C: Installation
C- 7
Advertisement
Table of Contents
