Tektronix AVG1 User Manual page 118

Appendix A: Specifications
A- 2
Table A- 1: Electrical specifications (cont.)
Characteristics
Frequency Response
Short Time Distortion
Line Time Distortion
Field Time Distortion
2T5 Pulse Ringing
2T5 Pulse Ringing, typical
K Factor 2T5 Pulse
Pulse/Bar Ratio, typical
DC Offset
Luminance Linearity Error
Chroma/Luminance Intermodulation
Dynamic Gain Error (10% to 90% APL)
Differential Gain
Hardware Modulated Signals
Software Modulated Signals, typical
Differential Phase
In-band Signal/Noise Ratio (S/N B020000 and above) (H/W version 2.2 and later)
Quiet Line
Slot 9 or 10
Slots 2- - 8
Full Amplitude Ramp
In-band Signal/Noise Ratio (S/N B019999 and below) (H/W version 2.1 and earlier)
Quiet Line
Full Amplitude Ramp
Description
Flat within 0.5% peak from 0.1 MHz to
6 MHz at 700 mV amplitude.
Typically 0.1% to 6 MHz and
8 MHz at 700 mV amplitude
1% peak. Measured with 2T bar.
0.5% peak. Measured with field square
wave, pedestal off.
0.5% peak. Measured with field square
wave, pedestal off.
1% peak
0.5%
0.5% peak
1:1 within 0.5%, with 2T5 pulse and bar
signal
10 mV
0.5%
0.5%
0.5%. Measured using 5-step ramp
while varying APL 10% to 90%.
0.1%
0.5%
0.5_
Typically 0.1_ on hardware modulated
signals, and 0.2_ on software modu-
lated signals
71 dB to 6 MHz, unweighted
73 dB to 6 MHz, unweighted
(75 dB typical, HW modulated signals)
(77 dB typical, SW modulated signals)
63 dB to 6 MHz, unweighted
(65 dB typical)
67 dB to 6 MHz, unweighted
60 dB to 6 MHz, unweighted
AVG1 Analog Video Generator User Manual
5% to