Belling BFS54SCDF Instruction Manual page 23

INSTALLATION
Installation Sequence
• Determine position of cooker and ant-tilt plate.
• Securely fix the anti-tilt plate to the floor with appropriate
fasteners.
• Fasten the stability bolt bracket to the front frame with the
2 screws supplied.
• Reposition the cooker back into the anti-tilt plate and then
mark the position of the stability bolt hole.
• Pull the cooker back out and drill the bolt location hole.
Use a 10mm masonry or wood drill. When drilling into
concrete ensure a minimum hole depth of 30mm.
• Reposition the cooker back into the anti-tilt plate, aligning
the stability bolt bracket with the 10mm drilled hole. Then
slide the bolt through the bracket and into the hole.
• Connect Electricity supply/gas supply but do not turn on until installation is completed.
• Slide the cooker back into the anti-tilt plate so that rear cover rests against the rear wall. Then
check the height and level of the cooker. If required, pull the cooker back out and adjust the
leveling feet as required.
Warning for installer
Only a qualified person in compliance with the instructions provided must install the
appliance. Manufacturer declines all responsibility for improper installation, which may harm
persons and animals and damage property.
Important: The power supply to the appliance must be cut off before any
adjustments or maintenance work is done on it; - Air duct is supposed to use in
Ventilation.
Assembly
When packaging is removed from product you will notice there are several items nested in
the packaging base. The burner crowns, burner caps and trivets can be fitted to the hob.
Note: That Wok trivet is a different size and must be correctly located over Wok
burner.
23