Installation - Belling BFS54SCDF Instruction Manual

INSTALLATION

Installing your new cooker
Safety warnings about installation
• The cooker must be installed and serviced only by an authorized person.
• A certificate of compliance must be supplied by Installer and is to be kept by the customer.
• The packing materials must be removed before you install the cooker.
• You must follow the installation instructions in this booklet.
• The surrounding kitchen cabinets must be able to withstand 85°C. We will not accept
responsibility for damage caused by installation in to kitchen cabinets which cannot withstand
85°C.
• The appliance must not be installed in a corner. It must be installed at least 100mm from the
side wall.
• The flexible pipe for gas models must have sufficient loops so the cooker can be moved for
service.
• The vents; openings and air spaces must not be blocked.
• The anti-tilt plate must be installed to avoid accidental tipping.
• The stabilizing bolt must be installed to avoid accidental moving.
• You must not pull the cooker by the door handles.
• Power socket, if provided for gas models, and electricity isolation switch for electric models
and gas models without a 20A plug, is to be installed in an accessible position near the
cooker (but not behind cooker).
• If the supply cord or cable is damaged, it must be replaced by an approved service agent or
a similarly qualified person in order to avoid a hazard.
Unpacking and installation Instructions for Installer
Unpacking
• Please check the product and make sure that there is no damage.
• Read the relevant Installation Sections of this Manual. Ensure understanding.
• Confirm that product is compatible with available electrical/gas supply. Ensure proposed
installation position does not conflict with Installation Sections.
• Check the attachment packing in good condition, complete accessories.
• Use screw driver to remove two fixed Anti-tilt plate screws and plate.
Locating the cooker
Study the diagrams following to be sure of the dimensions required to locate the cooker safely.
Make sure that the top of the cooker is at least 10mm higher than the level of the bench tops.
The appliance has been designed to fit in a 550mm wide gap in kitchen cabinets. The cooker
may also be installed at the end of a line of benches or with a free space on either side.
22