Installation; Assembling Torch - Kemppi FLEXLiTE TX Series Operating Manual

3. INSTALLATION

Ensure that the welding equipment is not connected to the mains or that the welding torch is not connected to the
welding machine at this stage.
Protect the equipment from rain and direct sunshine.
"Assembling torch" below
"Installing torch remote" on the next page
"Connecting torch" on page 10
Before installation and use
Ensure compliance with your local and national safety requirements regarding the installation and use of high
voltage units.
Check the contents of the packages and make sure the parts are not damaged.
Do not connect welding equipment to the mains before the installation is complete.

3.1 Assembling torch

1. Depending on your specific welding torch setup, assemble the torch starting with the insulating ring and collet
body.
Some Flexlite TX torch models also include a back cap insulating ring, in addition to the gas nozzle insulating ring.
2. Install the gas nozzle and the collet.
© Kemppi
6/24
Flexlite TX
Operating manual - EN
1920910 / 1921