Connecting Torch - Kemppi FLEXLiTE TX Series Operating Manual

2. Replace the standard start switch button on the cover with the extended start switch button.
3. Install the cover with the start switch extension in place.
4. Secure the switch cover in place with the two screws in the rear section of the cover.
The switch extension cannot be used with the S neck TX torch models.

3.3 Connecting torch

Hand tighten the torch connectors. Loose connectors may overheat, create contact disturbances, mechanical damage
and water or gas leakage.
For connecting the torch (and applicable extension parts), refer also to your welding equipment's instructions.
© Kemppi
10/24
Flexlite TX
Operating manual - EN
1920910 / 1921