Getting Started; Power Supply; Start-Up - PCE Health and Fitness VM 20 User Manual

4

Getting started

4.1

Power supply

The meter is powered by a rechargeable lithium polymer battery. For charging, connect the meter
to the power supply via the USB cable. If the meter is turned off and the connection is correct, a red
LED will glow during charging.
4.2

Start-up

To start the device, press and hold
logo starts glowing. The main menu will be shown as start screen. Make the following settings first.
To do so, go to "Settings" by pressing the navigation key
4.2.1 Date and time
In the sub-menu "Settings", use the
confirm with Enter . Press F1
the keys. Then release F1
Enter to get to the time setting.
Set the minutes by using the navigation keys
to go to „Hours". When this field has been selected, it will be bordered
in red. Set the hours with the navigation keys
by pressing Enter .
4.2.2 Sensors
The sensor setting is only relevant for vibration measurement. In the sub-menu „Settings", use the
to go to "Sensors" and confirm with Enter
keys
for vibration measurement. You can choose either the IEPE sensor (Sensor1) or a sensor with
charge output (Sensor2). Navigate to further settings with the Menu key
"Sens." can be changed via the keys
the navigation keys
unit for the respective sensor can be set to
mV/g or
The IEPE sensor is pre-selected.
for approx. 3 seconds, until the green LED below the PCE
keys to go to "Date/Time" and
and select the month and year with
and select the day. Confirm with
and the respective digit of the value can be selected via
. Under "Units", the
2
pC/ms .
© PCE Instruments
21
and confirm with Enter
. Press the Menu key
. Confirm your entry
. Use the keys to set the sensor used
.
. "Type", "S.N" and