Cisco 7000 Series Hardware Installation And Maintenance Manual page 229

•
Power supply (PWR-7010AC*), the 600-watt power supply for the Cisco 7010. Depending upon
the type of power cord required, the order number is as follows:
— PWR-7010AC=, with U.S. cord
— PWR-7010ACU=, with U.K. cord
— PWR-7010ACA=, with Australian cord
— PWR-7010ACE=, with European cord
— PWR-7010ACI=, with Italian cord
Figure 5-23 Internal Chassis Components
Power harness
cover
Handles
Figure 5-23 shows the locations of each of the internal components inside the service (noninterface
processor) end of the chassis. In addition to the internal components, the following assemblies are
also available as spares. This document does not include replacement instructions for chassis spares
or packing materials. However, specific replacement instructions, called configuration notes,
accompany all field-replaceable components.
•
Chassis without a power supply (MAS-7010=)
•
Chassis with power supply (CHAS-7010=)
•
Cable management kit (ACS-7010CBLM=); refer to the chapter "Installing the Router" for
installation instructions
•
Rack-mount kit (ACS-7010RMK=); refer to the chapter "Installing the Router" for installation
instructions
•
RP, SP (or SSP), and interface processors (various product numbers); refer to "Installing and
Configuring Processor Modules" in this chapter for replacement instructions
•
Repackaging container and materials (PKG-7010=) for moving or shipping the router safely
Arbiter cover
Power supply
Fan tray
Replacing Internal Components
Maintenance 5-71