Cip Leds - Cisco 7000 Series Hardware Installation And Maintenance Manual
Hide thumbs
Also See for 7000 Series:
- Command reference manual (1018 pages) ,
- Reference manual (746 pages) ,
- Configuration manual (536 pages)
Table of Contents
Advertisement
Interface Processor LEDs
•
Figure B-5
Following are the sequences for the CIP LED indicators. The enabled LED is not part of the
following sequences. On cold boots, the following four LED sequences apply:
Port 1
Port 0
Port 1
Port 0
Port 1
Port 0
The following sequence indicates that the CIP is waiting for commands from the RP.
Port 1
Port 0
On warm boots, the LEDs flash briefly. On downloads, the following three LED sequences apply;
the first indicates that the system is downloading volatile programmable logic device (VPLD) code:
Port 1
Port 0
The following sequence indicates that the CIP is downloading microcode:
Port 1
Port 0
B-4 Cisco 7010 Hardware Installation and Maintenance
Online—For the ECA, this LED indicates that an establish-logical-path request has been
received from the channel.
For the PCA, this LED indicates that the PCA is ready to establish connection to the host channel.
CIP LEDs
Present
Loaded
On
On
Off
Off
Present
Loaded
On
On
On
On
Present
Loaded
On
On
On
On
Present
Loaded
Off
Off
Off
Off
Present
Loaded
On
On
On
On
Present
Loaded
Off
Off
On
On
Signal
Online
Off
Off
Off
Off
Signal
Online
On
On
Off
Off
Signal
Online
On
On
On
On
Signal
Online
Off
Off
Off
Off
Signal
Online
On
On
On
Off
Signal
Online
Off
Off
On
On
Advertisement
Table of Contents
Troubleshooting
