Copying To The Flash Memory Card; Recovering From Locked Blocks - Cisco 7000 Series Hardware Installation And Maintenance Manual

Using the Flash Memory Card
To save the new configuration to memory, use the copy running-config startup-config command
as follows:
When you enter boot commands, pay attention to the use of the Spacebar, which influences the way
the router interprets the command. For example, notice the difference in the following commands:
In the first case, the router boots the file specified (
filename field blank, and boots the first file on the Flash memory card.

Copying to the Flash Memory Card

Copying to the Flash memory card might be required whenever a new image or maintenance release
becomes available.
Use the command copy tftp:filename [ bootflash | slot0]:filename for the copy procedure, where
tftp:filename is the source of the file and [ bootflash | slot0]:filename is the destination in onboard
Flash memory or on either of the Flash memory cards.
An example of the copy tftp:filename command follows:
Note
the "C" characters signify calculation of the checksum, which is a verification that the file has been
correctly downloaded to the Flash memory card.

Recovering from Locked Blocks

A locked block of Flash memory occurs when power is lost or a Flash memory card is unplugged
during a write or erase operation. When a block of Flash memory is locked, it cannot be written to
or erased, and the operation will consistently fail at a particular block location. The only way to
recover from locked blocks is by reformatting the Flash memory card with the format command.
Caution
be lost.
3-34 Cisco 7010 Hardware Installation and Maintenance
Router# copy running-config startup-config
Router(config)# boot system flash slot0:myfile
Router(config)# boot system flash slot0: myfile
Router# copy tftp:myfile1 slot0:myfile1
20575008 bytes available on device slot0, proceed? [confirm]
Address or name of remote host [1.1.1.1]?
Loading new.image from 1.1.1.1 (via Ethernet1/0): !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!![OK - 7799951/15599616 bytes]
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC
Router#
In the preceding example, the exclamation points (!!!) appear as the file is downloaded and
Formatting a Flash memory card to recover from locked blocks will cause existing data to
(correct command)
(incorrect command)
). In the second case, the router finds the
myfile