Cisco 7000 Series Hardware Installation And Maintenance Manual page 125

To ensure that the clip is not pulled off when adjacent interface processors are removed,
Step 3
position the clip parallel to the orientation of the AIP. (See Figure 3-8d.)
Figure 3-8 Installing the CAB-ATM-DS3/E3 Cable and EMI Filter Clip
Assembly—Horizontal Orientation Shown
a
To RX of switch
b
d
For additional information, refer to the Asynchronous Transfer Mode Interface Processor
Note
(AIP) Installation and Configuration configuration note (Document Number 78-1214-xx, where xx
is the latest version), which is available on UniverCD or in print.
White insulator
White insulator
To TX of switch
c
EMI filter
clip
Connecting Interface Cables
Installing the Router 3-13