Chassis Specifications - Cisco 7000 Series Hardware Installation And Maintenance Manual

Hide thumbs Also See for 7000 Series:
Table of Contents

Advertisement

Chassis Specifications

Table 1-2 lists the Cisco 7010 physical specifications and power requirements.
Table 1-2
Description
High-speed backplane
Dimensions (H x W x D)
Weight
Power dissipation
Heat dissipation
Input voltage
Power distribution
Frequency
AC current rating
DC-input voltage
DC voltages supplied and
maximum, steady-state
current ratings
DC-input power supply
hold-up time specification
DC-input power supply
cable guage
Airflow
Operating temperature
Nonoperating temperature –4 to 149°F (–20 to 65°C)
Humidity
Agency approvals
For a chassis footprint, additional dimensions, and clearance requirements for the router perimeter,
refer to the section "Site Requirements" in the chapter "Preparing for Installation."
Cisco 7010 System Specifications
Specification
533-Mbps CxBus, 3 interface processor slots plus RP, SP, and SSP slots
10.5 x 17.5 x 17.0" (26.67 x 44.45 x 43.18 cm)
Chassis depth including power cord and cable management fixture is 19" (48.26 cm)
Chassis only (including power supply and fan array): 46 lb (20.87 kg)
Chassis fully configured with 1 RP, 1 SP (or SSP), and 3 interface processors: 70 lb
(31.75 kg)
550W maximum configuration, 540W typical of maximum configuration with AC input
600W maximum configuration with DC input
715W (2440 Btu/hr)
100 to 240 VAC, wide input with power factor corrector (PFC)
70A maximum @ +5 VDC, 15A maximum @ +12 VDC,
3A maximum @ –12 VDC, 5A maximum @ +24 VDC
50 to 60 Hz
9A maximum at 100 VAC, 4A maximum at 240 VAC at 600W
–40 volts DC (VDC) minimum in North America (–56 VDC in Europe)
–48 VDC nominal in North America (–60 VDC in Europe)
–52 VDC maximum in North America (–72 VDC in Europe)
+5.2 VDC @ 75 amps (A)
+12 VDC @ 15A
–12 VDC @ 3A
+24 VDC @ 5A
10 milliseconds (ms) of output after the input has been interrupted
American Wire Guage (AWG)
10
Side-to-side through chassis by variable-speed, 6-fan array
32 to 104°F (0 to 40°C)
10 to 90%, noncondensing
Safety: UL 1950, CSA 22.2-950, EN60950, EN41003, AUSTEL TS001, AS/NZS 3260
EMI: FCC Class A, EN60555-2, EN55022 Class B, VDE 0878 Part 3, 30 Class B
Immunity: EN55101/2 (ESD), EN55101/3 (RFI), EN55101/4 (Burst), EN55101/5
(Surge), EN55101/6 (Conducted), IEC77B (AC Disturbance)
Physical Description
Product Overview 1-5

Advertisement

Table of Contents
loading

This manual is also suitable for:

70107000

Table of Contents