Tools And Equipment; Installing The Brackets; Connecting Power - Cisco 7000 Series Hardware Installation And Maintenance Manual

Connecting Power

Tools and Equipment

You will need the following tools and parts to install the cable management brackets; the brackets
and panhead screws are included with the chassis:
•
•
•

Installing the Brackets

Follow these steps to install the two cable management brackets on the router:
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
This completes the cable management bracket installation. Proceed to the next section to connect the
interface cables.
Connecting Power
Connect an 550W, AC-input power supply as follows:
Step 1
Step 2
Step 3
Connect a 600W, DC-input power supply as follows:
Step 1
Step 2
Step 3
3-8 Cisco 7010 Hardware Installation and Maintenance
Number 1 Phillips screwdriver
Two cable management brackets
Six M3 x 8-mm Phillips panhead screws.
Assemble the two cable management brackets and the six M3 x 8-mm Phillips panhead
screws.
At the interface processor end of the router, place a bracket on an inner side of the chassis
and align the three holes in the bracket with the holes in the chassis. (See Figure 3-5.)
Insert and finger-tighten three M3 Phillips screws from the inner side of the chassis,
through the bracket and into the chassis.
When all three screws are inserted, use the number number 1 Phillips screwdriver to tighten
the screws.
Repeat Steps 2 through 4 for the second bracket.
When installing the network interface cables, route the cable to the cable management
brackets as shown in Figure 3-5. If you are using very thin cables that slip through the
bracket openings, insert cable ties through the holes in the bracket and wrap them around
the cables to secure them.
Push the cable-retention clip down, away from the power cord port, and plug in the power
cord.
To secure the cable in the power supply AC receptacle, push the cable-retention clip up until
it snaps into place around the connector. The cable-retention clip provides strain relief for
the AC power cord.
Connect the power supply cord to the AC source.
Before proceeding, make certain the DC-input power cable is disconnected from the DC
power source and the power switch on the power supply is in the OFF (O) position.
Loosen the captive screws on the terminal block cover so it is free of the terminal block.
(See Figure 3-6a.)
Attach the 10-AWG ground wire to the ground terminal. (See Figure 3-6d.)