Cisco 7000 Series Hardware Installation And Maintenance Manual page 194

Installing and Configuring Processor Modules
Step 5
Figure 5-10
a
Step 6
Step 7
Step 8
Step 9
Step 10
Step 11
This completes the SIMM removal procedure. Proceed to the next section to install the new SIMMs.
5-36 Cisco 7010 Hardware Installation and Maintenance
While holding the extraction tool at the handle (at the top of the T), insert the embossed tip
into the hole in the right side of the SIMM. (See Figure 5-10a.)
Using the SIMM Extraction Tool
b
c
While pressing the tool downward (to keep the retainer spring depressed), rotate the tool
clockwise until the right side of the SIMM is partially released from the socket. (See
Figure 5-10b.)
Remove the tool from the right side, and insert the embossed tip into the hole in the left side
of the same SIMM.
While pressing the tool downward, rotate the tool counterclockwise until the left side of the
SIMM is released from the socket. (See Figure 5-10c.)
When both ends of the SIMM are released from the socket, grasp the ends of the SIMM
with your thumb and forefinger and pull the SIMM completely out of the socket. Handle
the edges of the SIMM only; avoid touching the memory module or pins, and the metal
traces or fingers along the socket edge.
Place the SIMM in an antistatic bag to protect it from ESD damage.
Repeat Steps 4 through 10 for the remaining SIMMs.
Insert extraction
tool into SIMM
socket and depress
retaining spring
Orient tool
as shown
Orient tool
as shown