Installation; Before First Use; Inserting / Changing The Battery - Silvercrest VE-6035SCR Assembly, Operating And Safety Instructions

Risk of damage of the product
Only use the specified type of
battery / rechargeable battery!
Insert batteries / rechargeable
batteries according to polarity
marks (+) and (-) on the battery /
rechargeable battery and the
product.
Clean the contacts on the battery /
rechargeable battery and in the
battery compartment before in-
serting!
Remove exhausted batteries /
rechargeable batteries from the
product immediately.

Installation

Note: A cross-head screwdriver is required to
assemble the product.
Remove the product and the accessories from
the packaging.
Assemble the base parts
cross.
Screw the pole
13
the mounting plate
screws to do this.
17
Remove the height adjustment ring
it anticlockwise.
Push the cap over the pole
14
height adjustment ring
Pull the internal pole
Secure the internal pole
adjustment ring
12
Remove the fastening screw
anticlockwise.
Push the motor
9
and attach it using the fastening screw
Turn it clockwise to tighten.
20 GB/IE
in the shape of a
16
to the base parts using
16
. Use the four cross-head
15
by rotating
12
. Then place the
13
back on the pole
12 13
out of the pole
11 13
by turning the height
11
clockwise to tighten it.
by turning it
10
onto the internal pole
11
.
10
Remove the rear grille locknut
turn it anticlockwise.
Place the rear grille
shown in Fig. D. Please ensure that the handle
on the rear grille
Attach the rear grille
locknut . Turn it clockwise to tighten.
5
Remove the protective cover from the axle
Push the blades
the smooth side of the axle
Place the blade cover
and turn it anticlockwise to tighten it.
Hang the front grille
using the hook
using the provided screw
Then close the fastening clamps.

Before first use

Place the product on a flat and stable surface
and ensure that there is a minimum of 10 cm of
clear space around the product. This product is
not suitable for connection or use in a cupboard
or outdoors.
Connect the mains cable to the socket.
Note: Before connecting the product, ensure
that the main voltage specified on the product
matches the local line voltage (Voltage:
220–240 V ∼).

Inserting / changing the battery

Open the battery compartment on the back of
the remote control.
Insert the batteries or replace the old batteries
. with new ones. Only use batteries of the speci-
. fied type („Technical data").
Note: When inserting the batteries, please
observe the correct polarity. This is indicated in
the battery compartment.
Close the battery compartment.
. To do this,
5
on the motor
6 9
is located at the top.
6
using the rear grille
6
onto the axle . Ensure that
4 7
is facing down.
7
onto the axle
3
on the rear grille
1
. Connect both grilles
2
and nut.
19
as
.
7
7
6
1 6