Weather Station; External Sensor - Auriol Z29962A Operating Instructions Manual

CAUTION! DANGER TO LIFE, RISK OF
INJURY AND MATERIAL DAMAGE! Read
the operating and safety instructions for your drill
carefully.
that you do not hit electricity, gas or water lines when
you drill into the wall. If necessary, check with a pipe
and cable detector before drilling.
©

Weather station

Mark the position of the hole (ø approx. 7 mm)
on the wall.
Drill the hole with an electric drill.
Insert the dowel
Using a Phillips screwdriver, screw the screw
into the dowel
Hang the weather station by placing the hanger
20
©

External sensor

Mark the position of the hole (ø approx. 5 mm)
on the wall.
Drill the hole with an electric drill.
Insert the dowel
Using a Phillips screwdriver, screw the screw
into the dowel
Hang the external sensor by placing the
hanger
Note: Choose a sheltered position for the external
sensor, not directly near the weather station (e.g.
separated by a wall). Ensure that the external sensor
does not come into contact with water or direct
sunlight. Electronic devices may adversely affect
the wireless signal reception.
16 GB/CY
64089_aur_Wetterstation_Content_LB7.indd 16
WARNING!
DANGER TO LIFE! Take care
into the drilled hole.
23
23 .
on the screw .
24
into the drilled hole.
28
.
28
on the screw
26
24
29
.
29
03.03.11 10:56