Switching On And Off; Working With The Lawnmower; Cleaning, Maintenance And Storage; Original - FLORABEST FRM 1200 D3 Translation Of The Original Instructions

A higher cut height should be se-
lected for the first cut of the season.
Observe the noise protection and
local regulations.

Switching On and Off

1. To relieve the strain, form a loop
with the end of the power cable
and hang this into the strain reli-
ef (11). See the diagram
2. Connect the equipment to the
power supply.
3. Before switching on, ensure that
the equipment is not in contact
with any objects.
4. To switch on, press the release but-
ton (10) on the handle at the same
time as pressing the start lever (12).
Release the release button (10).
5. To switch off, release the start
lever (12).
After switching off the equipment,
the blade continues to turn for sev-
eral seconds. Do not touch the mov-
ing blade. There is a risk of injury.
Working with the
Lawnmower
Regular mowing encourages increased foli-
ation of the grass and kills off weeds at the
same time. Therefore, not only does each
mowing increase the density of the lawn, it
also produces an evenly resilient lawn.
The first cut is to be made in around April,
at a growth height of 70 – 80 mm. In the
main vegetation period, the lawn is to be
mowed at least once a week.
• Start mowing near the socket and work
away from the socket.
• Always keep the extension cable be-
hind you and when you turn, move it to
the side that has already been mowed.
• Run the equipment at a walking pace,
in tracks that are as even as possible.
For gap-free mowing, the tracks should
always overlap by a few centimetres.
• Adjust the cut height so the equipment
is not overloaded. Otherwise, the mo-
tor may be damaged.
• On slopes, always work across the
. slope. Take particular care when going
backwards and pulling the equipment.
• Clean the equipment after each use, as
described in the chapter on "Cleaning,
Maintenance and Storage".
Switch off the equipment after work
and in order to transport it, discon-
nect the plug and wait until the
blade stops. There is a risk of injury.
Cleaning,
Maintenance and
Storage
Have work that is not described in
these instructions carried out by a
customer service centre that we have
authorised. Use only original parts.
Wear gloves when handling the
blade.
Switch off the equipment before all
maintenance and cleaning work,
disconnect the plug and wait until
the blade stops.
There is a risk of injury.
GB IE
27