Assembling The Grass Box; Operation; Hanging On / Removing The Grass Box; Adjusting The Cut Height - FLORABEST FRM 1200 D3 Translation Of The Original Instructions

GB

Assembling the Grass Box

D
1. Connect the two pieces of the
collection box (4).
2. Connect the handle (15) in one
of the two pieces of the collec-
tion box (16). The arrow mark-
ings on the handle (15) and at
the top of the grass grass (16)
show the alignment of the han-
dle (15).
Do not work with the lawn mower
without impact protection. There is
a risk of injury.
We recommend always using the
grass box when working with the
lawn mower, otherwise the mow-
ing result may be significantly im-
paired.

Operation

Hanging On / Removing the
Grass Box
E
1. To hang on the grass box (4),
lift the collision guard (7) and
hang on the grass box. Fold the
collision guard (7) onto the grass
box (4). It holds the grass box in
the correct position.
2. To remove the grass box (4),
lift the collision guard (7) and
detach the grass box. Fold the
collision guard (7) back onto the
mower housing (6).
D
The level gauge (
side of the grass catcher (4).
D
Flap ( 20) open:
grass catcher (4) empty
D
Flap ( 20) closed:
grass catcher (4) full
10
20) is located on the

Adjusting the Cut Height

Switch off the equipment, discon-
nect the plug and wait for the blade
to stop. There is a risk of injury.
The lawn mower can be set to the follow-
ing cut heights by means of three position
changes of the front and rear wheels, ad-
justing the individual wheels:
The single wheel adjustment has
always to be at least at one axis.
60 mm - Tall cutting height
40 mm - Medium cutting height
20 mm - Short cutting height
F
1. Unscrew the wheels (5).
2. Screw the wheels (5) back on in
the desired position. The single
wheel adjustment has always to
be at least at one axis
The correct height is around 25 – 40 mm
for a decorative lawn and around 30 – 60
mm for a used lawn.
A higher cut height should be se-
lected for the first cut of the season.
Observe the noise protection and
local regulations.

Switching On and Off

1. Insert the power cable plug into
the socket (
A
handle (
2. To relieve the strain, form a loop
with the end of the power cable
and hang this into the strain reli-
ef (11). See the diagram
3. Connect the equipment to the
power supply.
4. Before switching on, ensure that
the equipment is not in contact
with any objects.
A
9) on the curved
1).
.