FLORABEST FRM 1200 D3 Translation Of The Original Instructions page 23

4 Switch off the equipment and
disconnect the plug from the
socket if the power cable is
damaged. If the power cable is
damaged, it must be replaced
by the manufacturer, the cus-
tomer services of the same, or
a qualified person, in order to
avoid hazards.
5 Do not connect a damaged
power cable to the mains. Do
not touch a damaged power
cable when it is connected to
the mains. A damaged power
cable may result in contact with
live parts.
CAUTION! The following
states how damage to the ap-
pliance and possible injury to
people can be avoided:
In this way you avoid damage
to the appliance and possible
injury to people.
Working with the Equipment:
Do not place feet or hands
near or under rotating parts
when working. Risk of injury!
Observe the noise protection
and local regulations. The
use of the equipment may be
restricted or prohibited on cer-
tain days (e.g. Sundays and
public holidays), at certain
times of day (lunchtimes, night-
times) or in certain areas (e.g.
health resorts, hospitals etc.).
• Switch on the motor accord-
ing to the instructions and only
when your feet are at a safe
distance from the cutting tools.
• Do not use the equipment in
the rain, in poor weather, in a
damp environment, or on wet
grass. Work only in daylight or
with good lighting.
• Do not work with the equipment
when tired, lacking concentra-
tion or under the influence of
alcohol or drugs. Always take
breaks in good time. Take a
sensible approach to the work.
• When working, ensure a firm
stance, particularly on slopes.
Always work across the slope,
never upwards or downwards.
Take particular care when
changing the direction of travel
on the slope. Do not work on
excessively steep slopes.
• Run the equipment only at a
walking pace. Take particular
care when turning the equip-
ment around, pulling it towards
you or going backwards.
• Switch on the equipment care-
fully and in accordance with
the directions in these instruc-
tions. Ensure sufficient distance
between feet and the rotating
blades.
• Do not tilt the equipment when
starting other than if it is nec-
essary to do so when starting
up in long grass. In this case,
tilt the equipment by pressing
down the handle bar such that
the front wheels of the equip-
ment are raised. Always check
that both hands are in the work-
ing position before returning the
equipment to the ground.
• Do not work without the grass
box or collision guard. Keep
GB IE
23