Control Card Terminal Identification - TDE MACNO DVS200 User Manual

5.3.2. Control card terminal identification

No. Terminal Description
1 REL-CM Digital output 1
2 REL-NO Digital output 1
3 REL-NC Digital output 1
4 +15 V OUT
+15V
5 IN 1 Digital input 1 Programmable digital input 1
6 IN 2 Digital input 2 Programmable digital input 2
7 IN 3 Digital input 3 Programmable digital input 3
8 IN 4 Digital input 4 Programmable digital input 4
9 GND 0 V
10 IN AN 1 Analog input 1
11 +10V + 10 V OUT
15 GND 0V
16 FB + Link +
17 FB - Link -
Control connection data
Rigid / Flexible / wire size
Flexible with spade end with/without insulating collar
Stripping length
28 • Chapter 5 - Electrical Connections
Figure 5.3.2.1: Control card terminal identification
FUNCTION
Programmable
relay output
Auxiliary power for digital inputs
Reference ground for analog input
Programmable analog input
Auxiliary power for potentiometer
Reference ground
Serial line +
Serial line -
Table 5.3.2.1: Maximum wire sections for control card terminals
Table 5.3.2.2: Maximum wire length
Wire section [mm2]
Maximum length [m]
Common
Norm.Open I-100=1 ALARM
Norm.Closed
I-100=1
I-100=3
I-100=2
I-100=7 Freq.Sel.
I-200=1
2
[mm ] / [mm
Maximum wire length
0,5 0,75
30 60
Default
Signal type
Switching capacity: 230
Vac, 0.2 A; 30 Vdc, 1A
15V +/-5% 300mA
7mA at 15V opto-
RUN
EF couplers for PNP logic,
REV active connected to
0-10V, 0-20mA, 4-20
0-10V
10 V +/-3% 50mA
RS 485
2
] / AWG 0,22-1 / 0,22-1 / 26-18
2
[mm ]
0,25 - 0,34 / 0,25 - 0,34
[mm]
1
90
+15V
mA
10
User Manual