New Filter Dial - Electrolux EWX11831 Service Manual

12.5.4 New Filter dial

Until now, the loading circuit was drained as described below:
 For some machines it is necessary to disconnect the drain pipe from the back panel, positioning it as low
down as possible to drain any remaining water from the inside of the drain circuit.
 In other machines, there is a small hatch at the bottom of the front panel, from which it is possible to access
the filter dial. Close to this is a small pipe that can be used to drain the water, after the plug has been
removed from it.
 For machines manufactured with the new filter dial: open the flap at the bottom of the front panel. The filter
knob is as shown in Fig. 1.
To drain the water, simply:
 Press the two tabs that secure the closing lever to the plug Fig. 2.
 Simultaneously extract the top part of the lever as shown by the yellow arrow in Fig. 3.
 Arrange the closing lever as shown in Fig. 4.
Fig. 1
12.6 Electronic control
12.6.1 Programming/Updating the main circuit board


In the Service Notes the main circuit board (587) is identified with two spare parts
codes:
 Code 973 914... identifies the pre-programmed board.
 Code 132... identifies the unprogrammed board.
The circuit board can be programmed/updated using the Sidekick application.
For further information, please refer to the instructions provided/illustrated in the course
entitled << Sidekick Guide >> at the link (http://electrolux.edvantage.net) on the
Electrolux Learning Gateway portal.
To update/program the main board,
insert the Sidekick connector in the
position shown by the red arrow:
Technical Support - DMM
Fig. 2
Any programming/updating/diagnostics operation carried out with the board
installed on the appliance and the mains plug disconnected from the socket.
If one of these operations is accidentally carried out when plugged in to the
socket, on completing the operation, the appliance will remain turned off when
restarting; disconnect the plug from the socket and wait at least 40 minutes
before starting up the appliance (any operation will only create further delay).
Fig. 3
EWX11
47/106
Fig. 4
587
EWX14
599 77 23-65 Rev. 03