Plastic Pulley - Electrolux EWX11831 Service Manual

16.6.2 Plastic pulley

Remove the back panel (see relevant chapter).
Remove the belt (see relevant chapter).
Insert a retainer to secure the pulley in place.
Unfasten the screw securing the pulley to the drum shaft.
Tighten the screw at a torque of 60 Nm.
16.6.3 Inverter
Remove the back panel (see relevant chapter).
Loosen the two screws that fix it to the cabinet.
Pull out the clamp from the cabinet.
Push the washing unit towards the inside of the appliance (if necessary).
Pull out the connectors of the heating element (if necessary).
Remove the Inverter (UIMC).
Disconnect the hooks fixing the connector protection on one side.
Then on the other.
Remove the connectors protection.
102/106
Technical Support - DMM 599 77 23-65 Rev. 03