Dial And Buttons - Electrolux EW6T4613HA User Manual

7. DIAL AND BUTTONS

7.1 Introduction
The options/functions are not available
with all washing programmes. Check the
compatibility between options/functions
and washing programmes in the
"Programme Chart". An option/function
can exclude another one, in this case the
appliance doesn't allow you to set
incompatible options/functions.
7.2 Marche/Arrêt
Press this button for a few seconds to
activate or deactivate the appliance. Two
different tunes sound while switching the
appliance on or off.
As the Stand-by function automatically
deactivates the appliance after several
minutes to reduce the energy consumption,
you may need to activate the appliance
again.
For more details, refer to Stand-by paragraph
in Daily Use chapter.
7.3 Temp.
When you select a washing programme, the
appliance automatically proposes a default
temperature.
The indicator Froid = cold water.
The indicator of the set temperature comes
on.
7.4 Essorage
When you set a programme, the appliance
automatically sets the maximum spin speed
allowed except programme Denim.
Additional spin options:
• No Spin . The related indicator comes
on.
Set this option to deactivate all spin
phases. The appliance performs only the
draining phase of the selected washing
programme. Set this option for very
delicate fabrics. The rinse phase uses
12 ENGLISH
more water for some washing
programmes
• Rinse Hold . The related indicator
comes on.
The final spin is not performed. The water
of the last rinse is not drained out to
prevent the fabrics from creasing. The
washing programme ends with water in
the drum.
The lid stays locked and the drum turns
regularly to reduce creasing. You must
drain the water to unlock the lid.
If you touch the Départ/Pause
the appliance performs the spinning phase
and drains the water.
• Nuit . The related indicator comes on.
The intermediate and the final spinning
phases are suppressed and the
programme ends with water in the drum.
This helps to reduce creasing. The lid
stays locked. The drum turns regularly to
reduce creasing. You must drain the water
to unlock the lid.
As the programme is very quiet, it is
suitable for use at night time when
cheaper electricity tariffs are available. In
some programmes the rinses are
performed with more water.
If you touch the Départ/Pause
the appliance performs only the draining
phase.
The appliance empties the water out
automatically after approximately 18
hours.
7.5 Prélavage
With this option you can add a prewash
phase to a washing programme.
The relevant indicator illuminates.
• Use this option to add a pre-wash phase
at 30 °C before the washing phase.
This option is recommended for heavily
soiled laundry, especially if containing
sand, dust, mud and other solid particles.
button,
button,