Motor - Electrolux EWX11831 Service Manual

Carefully remove the connectors (they are blocked by anti-sliding hooks).
CAUTION:
Position the wiring carefully when re-assembling the UIMC / EMC14
(Inverter) and set it out as shown in the figure, inside the two rails cut into
the UIMC / EMC14 lid (indicated by the arrows).
This is to avoid any wire being squashed/pressed against the cabinet with
the risk of current leakage.

16.6.4 Motor

Remove the back panel (see relevant chapter).
Remove the belt (see relevant chapter).
Disconnect the connectors: power supply and earthing (blue arrow) and also
slip off the strap.
Loosen the two front fastening screws (1) and the rear ones (2) (red arrows).
When reassembling, restore the connections.
If the clamp securing the wiring to the motor breaks, replace it with a new one.
Tighten the screws at a torque of 5 Nm.
16.6.5 Heating
Remove the back panel (see relevant chapter).
Disconnect the connectors of the heating element (1), NTC probe (2) and
earth (3) red arrows.
Unscrew the nut (blue arrow) and remove the heating element from its seat.
Tighten the nut at a torque of 4 Nm.
16.6.6 Water control
Remove the back panel (see relevant chapter).
Release the hooks securing it to the bottom and disconnect the connector.
Technical Support - DMM
103/106
1
1
2
1
1
3
2
599 77 23-65 Rev. 03
90
80
70
60
50
40
30
20
10
0
1°
Trim. T