Detergent Fill Pipe - Electrolux EWX11831 Service Manual

Remove the detergent dispenser.

16.2.8 Detergent fill pipe

Remove the worktop (see relevant paragraph).
Remove the control panel (see relevant paragraph).
Remove the detergent tray (see relevant paragraph).
Pull out the pipe from the detergent dispenser after breaking/loosening the
clamp between the detergent dispenser and the detergent loading pipe.
When reassembling, use a new clamp with the same characteristics.
The size of the clamp to use is 65.5 mm.
When introducing the pipe into the dispenser, make sure the two
references are aligned.
16.2.9 Upper counterweight
Remove the worktop (see relevant paragraph).
Remove the three screws that secure it to the welded tub.
When reassembling:
If the tub assembly is new, tighten the screws at a torque of 20 Nm.
If the tub assembly is not new, align with the existing thread and tighten the
screws at a torque of 15 Nm.
16.3 Accessing the front part
From the front it is possible to access the following components:
1. Door and Door Hinge
2. Door safety interlock
3. Drum light
4. Bellow seal
5. Blade
6. Front panel
16.3.1 Door hinge - Door
To replace the hinge, loosen the screws securing it to the cabinet.
To access the door, loosen the screws joining the two front and rear door
frames together.
88/106
Technical Support - DMM 599 77 23-65 Rev. 03