Ec4: Ags Current Sensor Faulty Error; Ef1: Drain Hose Blocked/Kinked/Too High; Drain Filter Clogged/Dirty; Ef2: Excessive Detergent Dosing; Drain Hose Kinked/Blocked; Drain Filter Dirty/Clogged; Ef3: Aqua Control Device Triggered - Electrolux EWM09312 Service Manual

Hide thumbs Also See for EWM09312:

Service manual (70 pages)

Service manual (124 pages)

Table Of Contents

Table of Contents

EC4

Checks to perform:

Replace the main circuit board and run the diagnostic cycle to check for any further alarms.

EF1

EF1: Drain hose blocked/kinked/too high; drain filter clogged/dirty

Checks to perform:

This warning only appears at the end of the cycle. The appliance detected long drainage phases during

the cycle. (E.g.: More than 20 seconds when draining after rinses). Check/clean the drain filter.

EF2: Excessive detergent dosing; drain hose kinked/blocked; drain

EF2

Checks to perform:

This is an excessive detergent dosing warning. The system detected too much foam was forming during

the drain phases. Advise the Customer to use the correct quantity of detergent and to make sure the

EF3

Checks to perform:

This warns about the presence of water at the bottom of the appliance. Check for any water leaks and

Or caused by excessive overheating of the drain pump. Check for any items which may obstruct the

EF4

EF4: Water fill pressure too low and solenoid valve open

Checks to perform:

It is a warning that the water pressure is too low. If the water pressure is correct, check:

2012 SOE/DT-mdm FCPD-dp

Guide to diagnostics of EWM09312 electronic controls