Electrolux EWX11831 Service Manual page 29

 Sensor no. 7: START/PAUSE
Touch the sensor with your finger to START or PAUSE the
appliance.
It is related to LED (L1), which flashes when the appliance is on
pause, whereas it is lit continuously when the appliance is
performing a washing cycle.
 Sensor no. 8/9: MEMORY
Touch one of these sensors with your finger to store or recall
a stored programme.
When the selected programme has been optimised with the
desired options, it can be saved in one of the two memories by
touching the related sensor (s8/9) for approximately 3 seconds.
The buzzer "beeps" once and the LED (L2/3) corresponding to
the memory lights up and the words "Programme saved" are
displayed in the text line to show that the operation was
successful. To recall the stored programme, simply touch the
sensor (s8/9) of the memory concerned, the corresponding LED
(L2/3) lights up and the LCD displays the settings of the
programme saved (selector LED, options, time left and the words
"Memory programme" are displayed in the text line for
approximately 3 seconds).
If a sensor of the memory which contains no stored programmes
is touched, the buzzer "beeps" once and the corresponding LED
stays on and the words "Memory is empty" are displayed in the
text line for approximately 3 seconds.

Sensor no. 10: STEAM (where featured)
Touch this sensor with your finger in sequence to select among
the three steam intensity levels shown by the lighting of LEDs
L4/L5/L6.
The text line displays the status of the option.
Technical Support - DMM
29/106
599 77 23-65 Rev. 03