Chapter 1 Content Description Section 1 On-Lap Monitor and Accessories Parts Description Fig.: 1002 buttons and LED light Description Fig.: On-Lap 1002 input/ output ports Fig.: Parts Description of Protective Cover...
Page 4
Package & Accessories Accessories On Lap 1002 Protective Cover 1 pcs; Magnetic Clip 1pcs Micro USB to USB Touch Power Cable 1 pcs Micro HDMI Video Cable 1pcs VGA Video Cable 1 pcs No (Optional) Charger (5V,Max.2A) x1 No (Optional) Stand 4 x1 No (Optional) (Screw + Nut)* 4 sets;...
will not be pressed if need to carry it outdoors. Placing touch screen monitor inside carrying bag may result in monitor glass damaged by pressing, dropping or colliding with laptop and other items. Place the monitor in protective cover, and carefully make sure the screen glass will not be pressed or touched.
Page 6
1 Install Protective Cover 1-1Open the Protective Cover Stand, place the monitor into the Protective Cover, place the magnetic clip on top (Place the short side of the Magnetic Clip on the top). Fig : Protective Cover as screen stand 1-2 Close the Protective Cover Stand, place monitor in protective cover, with the back facing out, place the magnetic clip on top (Place the long side of...
Connect USB Touch Output and Power Cable’s Micro USB (B type) con- nector to On-Lap 1002’s Micro USB port. Connect the other end, USB con- nector to USB port of laptop. With this connection, laptop will provide power and touch signal to On-Lap 1002.
Page 8
D-Sub/VGA connector port on the laptop. *The two On-Lap 1002 video cables look similar in appearance, match with the dia- gram before connecting to avoid connecting to the wrong port. If wrongly connect Micro HDMI Video Cable to VGA port, or wrongly connect VGA Video Cable to HDMI port, the monitor will not display.
5V 2A Charger to provide 5V DC and not use power from laptop, please refer to diagram. Connect 5V 2A Charger to Micro USB port (DC IN) of On-Lap 1002. At this time, On-Lap 1002 will only use power from DC IN port.
As below Fig., please select “Setting (S)”, when Windows message appears on the screen of On-Lap 1002, follow the direction to touch the screen and the setting is complete. Section 4 Windows 8.1/ 10 Touch Gesture Description...
Swipe in from the left edge of the screen (Arrow 2) : Switch be- tween apps Swipe in from the left edge of the screen then out toward the left edge of the screen (Arrow 3): Dis- ...
Section 2 OSD Description Basic Button Operation Press button to launch the OSD panel. Press to view the func- tions. To adjust a certain function, press to launch it. If the selected function consists of sub-menu, press again to view the sub-menu. When the desired function is highlighted, press to launch it.
Page 13
Notice: When use 4:3 setting, the left and right sides of On-Lap 1002 will show black frame. Because its not full screen image display, thus image location and touch signal location will not be the same, will not be able to touch the...
Section 3 Low Power Protection Warning If the volume setting is too high, the power requirement may be greater than the power provided by computer or external 5V DC Charger. At this time, the Low Power Protection Warning will appear. Please reduce the volume immediately.