Mounting Dimensions Of Gb-Series - MTS Systems Temposonics GB Series Brief Instructions

Temposonics GB-Series
®
Brief Instructions
Magnet mounting with magnetic material
A
1
2
Magnet
3
Null zone, depends on sensor model
1
Distance between position magnet and any magnetic
2
material (≥ 15 mm)
Non-magnetic spacer (≥ 5 mm) –
3
Recommendation: 8 mm
Magnet mounting with magnetic material
A. If the position magnet aligns with the drilled piston rod
B. If the position magnet is set further into the drilled piston
rod, install another non-magnetic spacer above the magnet
Manuals, Software & 3D Models available at:
www.mtssensors.com
B
Magnetic
material
Magnet
3

4.3 Mounting dimensions of GB-Series

GB-Series with pressure fit flange
with ring / U-magnet
Reference edge of mounting
40
GB-Series with threaded flange with ring / U-magnet
Reference edge of mounting
40
NOTICE
On all sensors, the areas left and right of the active stroke
length are provided for mounting and damping of the mea-
suring signal. They could not be used for measurement,
but the active stroke length can be exceeded.
I 8 I
Start position
Stroke length
Start position
Stroke length
All dimensions in mm
63.5
63.5