Advertisement
Application Manual
Hotel rooms – room automation
Radiator in the room and the bathroom, sun protection, presence-
dependent switching off of lighting and power supply
Features
·
·
·
·
·
·
·
Room setup
Individual room temperature control, heating
Two control loops for the room and the bathroom
Window contact – central detection of open windows
Detection of presence via hotel card switch
Presence- and time-dependent control of HVAC, lighting, sun protection, and power
supply to the room
Central operation and display of HVAC, lighting, and sun protection
Pushbuttons for "SOS", "Make up room", and "Do not disturb"
1.
UP 227 room operator unit: The UP 227 acquires the room temperature and sends the temperature
value, the setpoint shift and the operating mode to the AP 562/02 via the KNX bus. The UP 227 can also
be used to control the lighting and the blinds.
2.
AQR2532 room sensor with AQR2570 basic module: The AQR acquires and controls the room
temperature in the bathroom via the radiator.
3.
AP 562/02 valve actuator: The AP 562/02 drives the radiator valve. It receives the positioning signal from
the UP 227 or the AQR controller.
4.
AP 118 automation module box: The AP 118 has a socket for room automation modules type RS or RL.
5.
RS 525/23 universal dimmer: The RS 525/23 features a relay contact to dim a lighting group up to 250
VA.
6.
RL 521/23 blind actuator: The RL 521/23 features 2 relay contacts to control blinds.
7.
RS 510/23 binary output, 2-fold: The RS 510/23 features 2 relay contacts to switch electric circuits.
8.
S 290 door/window contact: The window contact causes the room operating mode to change to
Protection when the window is open.
9.
DELTA pushbutton: The pushbutton is connected to the UP 220 and is used to control the lighting.
Nr. 06
Synco™
& Gamma
35
Advertisement
